Travel Sippy Cup Holders

I don't normally post more than one blog a day, but I had to put this on as soon as I finished because I was so excited about it. I had to take the kids to the doc yet again today, and on the way home they simultaneously dropped their sippy cups in the floor of the van. Well of course I couldn't reach them, so I got to listen to the poor pitiful cries of two thirsty babies...Then it hit me. I MUST do something about this. When I got home, I got online to see how much sippy cup holders were..the ones that the kids can reel in after they drop them, and they were around $10-$15 each. I have 2 kids...not happenin'. So I pulled out a notepad and started sketching and came up with a design that I thought would work and got to cutting. Here is a tutorial for all of you frustrated mothers whose lil' ones have the dropsy's at the wrong time too:o)
What you will need:
-Fabulous fabric(around a 1/2 yd?)
Cut:
*(1)12 1/2" x 11" square..I guess it really isn't a square if it isn't...square?
(this is the holder fabric section)
*(2)Circles 4 1/2" in diameter(bottom)I used my circle cutter to make a pattern
*(1)22" x 4" strip(strap)
-1/2" Elastic strips(2), 8" & 7 1/2"


Fold the holder fabric in half(the 11" length) and press.


Using your iron, fold the strap in half and press. Then fold each edge towards the center line and press again. This prevents any flipping of which I absolutely detest:o)


Stitch as close to the edge of the strap as possible. Make sure that there aren't any places that slipped and did not get stitched. Fold under one end of the strap and stitch making sure raw edges aren't showing.


Fold finished edge over 3 3/4" over and stitch.


Take the holder fabric and stitch 5/8" to the left of the folded edge. Then stitch another line 2 inches to the left of that. Then another line 5/8" from the second stitched line. These are the slots for your elastic strips.


Grab your 2 elastic strips along with a safety pin to help you run them thru your slots.


Take your 2 elastic strips and run them thru your slots. The 8" strip goes on top and the 7 1/2" strip goes on the bottom. Make sure to have something at each end so that the strips don't slide back thru. Place right sides together. Make sure to add the strap on the inside matching all raw edges. Stitch. Back stitch over the strap for extra strength.


Take the 2 circles that you cut out and put wrong sides together. Baste around the edges so that there isn't any slippage. Now put one of the right sides of the circle and the right side of the holder together matching bottom edges and stitch. Turn right side out.(Sorry that there isn't a pic, forgot to take one)

Slide a cup in to make sure that all stitches are secure and that there aren't any gaping holes;o)



How to attach the holder to your car seat:

Slide strap around bottom of car seat strap as shown here.


Slide the holder thru the loop


Now just pull all the way thru.


Insert cup, and there ya have it! A sippy cup that will never be lost again...unless they try to physically remove it from the holder:o)

Tweet

Pin It